Audioarts TS-1 Headphone Amp
Audioarts TS-1 Headphone Amp
Audioarts TS-1 Headphone Amp
Audioarts TS-1 Headphone Amp

Audioarts TS-1 Headphone Amp

014001

Regular price $490.00
/

Audioarts TS-1 Headphone Amp Talent Station

The Audioarts TS-1 is a tough, compact countertop unit that utilizes a high-gain headphone amplifier that multiplies voltage and current to provide GREAT, LOUD sound to headphones of any impedance. It features 1/4” and mini stereo output jacks, two panel switches with internal LEDs, a power light and a level control. An internal HI/LO gain switch lets you match a wide range of input types.

There's a LOGIC RJ45 that lets you to use the two front panel switches for TB, COUGH and other functions. INPUT and OUTPUT connectors follow standard Studio Hub RJ45 analog audio pinouts. The OUTPUT feed allows you to daisychain the unit’s source audio to other devices. USB power supply and cable included.

WIRING is through cutouts in the bottom of the unit: input, output and logic RJ45 connectors, plus USB power. A HI/LO gain set switch is located below the input connector.

TS1 Bottom Callouts

CONNECTIONS: The USB port provides +5VDC power to the amp. The LOGIC RJ45 lets you to use the two front panel switches for TB, COUGH and other functions. INPUT and OUTPUT connectors follow standard Studio Hub RJ45 analog audio pinouts. The OUTPUT feed allows you to daisychain the unit’s source audio to other devices. TS1 Pinouts Callouts

COUNTERTOP MOUNT:  To install the TS-1 you will need to drill six holes in your countertop: four thru-holes for wire passage (5/8” diameter spade bit, shown in red) and two mounting holes (1/8” drill bit, A and B) for the 3/4” screws that will hold the unit in place. 

A drilling template is included in the packing box. TS1 BottomTemplateCallouts

Once the wiring is connected and everything is working properly (don’t forget to set the HI/LO gain switch) it’s time to fasten the TS-1 to the counter.

To do this you need to remove the unit’s two acrylic sideplates (each held in place by three philips head screws). You can then drive home screws through the A and B counter mounting holes in the bottom plate (sharp point 3/4 inch #8 sheetrock screws recommended).

Once anchored in place, close up the unit by replacing the sideplates.TS1 OPEN SIDEPLATE v2

 Specifications For TS-1

TS1 FREQ GRAPHGAIN:  +5dB LO setting, +14dB HI setting

DISTORTION: 

THD+N .003%

IMD .005%

SMPTE DIN .002% 

NOISE:  -92dBu 20KHz BW, unweighted

MAXIMUM OUTPUT: 

voltage +20dBu

power 650mW

current 120mA

MAXIMUM INPUT LEVEL:  +26dBu

DYNAMIC RANGE:  112dB

CMRR:  80dB

DIMENSIONS: width 5.4”/13.7cm, height 1.8”/4.6cm, depth 3”/7.6cm

WEIGHT: 10oz/.28kg